Electrical power short circuit protection
All of the SkidWeigh systems are internally short circuit protected with resettable fuse. There is no need to
install external inline fuse in orange wire connected to the ignition switch.
The
OP-LCM
system has a reversal power supply protection.
“Quick test to determine if electrical connections are done right”
Note:
SkidWeigh
OP-LCM
calibration function is not done yet at this stage.
This procedure is only to test if electrical connections of the system
electrical wires into the vehicle is done properly!
After you have connected electrical power and pressure transducer cable
on master indicator you can “quickly” check the system operation.
-
Lower the forks to the ground
- Turn on vehicle power switch
- Digital LED display will be activated, showing software version and serial
number
- Number
8
will be shown on LED display above the
MODE
digit.
-
Lift the empty or loaded forks to increase pressure in lifting cylinder.
Number
8
will go off and indicator will show “some”load in percentages on LED display.
If the above test
is valid the system electrical connections are done right.
The next procedure will be to calibrate the
OP-LCM
system.
-
Note:
If the slave indicator is connected the Blue LED light will be activated automatically. Bluetooth
pairing between MASTER and SLAVE is successful
.
-
Note:
The slave indicator will show the same readout as the master indicator.
The system calibration procedure is done on MASTER INDICATOR
The
OP-LCM Series SkidWeigh
calibration is automatic and is done by lifting empty forks with operator
on platform
just above the ground.
The calibration with the known load weight is done with
loaded
forks and platform at the highest operational forks height
for the particular high reach order picker
truck.
MAKE SURE THAT YOU HAVE A KNOWN LOAD WEIGHT AND KEEP IT NEARBY TO COMPLETE THE
CALIBRATION.
For the best results use minimum calibration load test weight of 40% to 70% of the vehicle maximum
lifting capacity of the vehicle at the highest forks height as stated on vehicle name plate.
(Consult vehicle name plate for vehicle maximum lifting capacity at the maximum forks height)
Use customer floor scale or use a known skid load weight for the OP-LCM calibration.
Integrated Visual Data Technology Inc. 3439 Whilabout Terrace, Oakville, Ontario, Canada L6L 0A7
