To change these levels, follow these steps:
1. Touch Function Button once to get into power control.
2. Touch Value + and Value - buttons until desired power level is reached.
3. Touch Function Button again to get into temperature control.
4. Touch Value + and Value - buttons until desired temperature level is reached.
Overheating Protection Feature:
Your induction cooktop is equipped with an overheat protection system. In the event that a pot or pan gets too hot, an audible
alert will sound, the Digital Display will read “E0”, and the cooktop will automatically shut off. Allow a few minutes for the
cooktop to cool down, after which it should work without issue.
Working the Timer:
The timer can be set in the range from 0 minutes to 180 minutes (3 hours) in increments of 1 minute. Upon power on, the timer is
always set to 0 minutes.
- After setting power and temperature, touch Timer Button. “0” digit will flash.
- Touch Value + Button to increase timer level by 1-minute increments.
Note! Holding down value buttons causes count to speed up to 10-minute increments.
- Touch Timer Button to confirm timer level.
- Timer will shut heating element when it reaches “0”.
- To cancel timer at any time, Touch Timer Button.
Locking the Controls:
- To avoid accidental mode changes, touch Lock Button. All buttons will be disabled and red indicator above lock icon
will
illuminate.
- To unlock cooktop controls, touch and hold Lock Button for three seconds.
Troubleshooting
To help troubleshoot issues, the cooktop is designed with an error code system. Should a code be displayed, use the table below
to determine the cause of the problem and apply the correct solution.
Error Message
Possible Cause
Solution
E0
No pan/incompatible pan detected
Place compatible pan on cooktop
E1
Temperature is too high
(or) The fan inside is not working
(or) The sensor has failed
• Clean the ventilation slots if blocked.
• Let device cool off for a few minutes, then try
to operate the device again.
• Contact supplier to repair
E2
Sensor has failed (or)
The temperature of the pan is too high
(when the pan is dry or incompatible,
temperature will be very high and the
unit will cut the power to protect the
IC chip)
• Remove the cookware, let the device cool off
for a few minutes, and then try to operate the
device again.
E3
The voltage is incorrect.
Check if voltage is correct, then try to operate
the device again.
