4
1. Connect the power cable to a wall outlet
and use the power button to turn the
device on. The unit will play a series
of tones (“do, rei, mi” for the more
musically-inclined) while it
conducts a self-test. The LCD
display screen will show “00”.
2. After turning the device on, each time you press the plus key (+) on the purifier,
it will add five minutes to the run time. The maximum run time on this appliance
is 30 minutes. Each time you press the minus key (–), it will reduce the run time
by 5 minutes. The minimum run time is 5 minutes (technically it’s 0 minutes, but
that would accomplish nothing).
3. Five seconds after you set the run time for the unit, it will start working. The timer
will count down the remaining time, and at the end of the countdown, the machine
will stop working and display “00” along with a series of tones (“mi, rei, do” if
you’re a student of music theory). The air pump stops running five seconds after
the machine stops running in order to prevent malfunctions.
4. To skip the process of setting the timer, you can simply press the “POWER” button
a second time after the purifier has been turned on and it will start running. The
default timer setting is 5 minutes. You can then press the plus and minus keys to
adjust the timing.
5. To pause the machine during operation, press the power button once while the
purifier is running. This will cause the purification to pause until you press the
power button a second time to resume the process.
6. Once the machine finishes running, pressing the power button once will cause
the purifier to start up again with the previous timer setting as the current default
setting. If the machine had been set to 20 minutes and finishes the process,
hitting the power button will cause it to start another 20-minute cycle.
7. To purify the air in the room, remove the silicon tube from the purifier and allow it
to run in an unoccupied space. To purify water, or objects in water, place the silicon
tube (with or without the ball) into a sink or container full of water (and the objects
you want to purify, if any), and allow it to run for the recommended amount of time.
USING THE PURIFIER
