7
To clean each plate:
1. Turn the unit OFF via the power button and the power switch at the rear. Wait for the fan to stop spinning and then
unplug from the outlet.
2. Remove all the filters preceding the plates from the rear of the unit by unscrewing the black knob that holds the
rear cover in place.
3. Pull each ozone plate gently, but firmly, toward you and out of the unit.
4. Wash the plate carefully, with warm water applied to both sides of the
plate to rinse it well. If you prefer to use clear ammonia, you can do a
mixture of warm water and ammonia (a 50/50 mixture is best) and
allow the plate to soak in the mixture for about 10-15 minutes.
5. Gently scrub with a stiff brush if you notice any deposits not coming off
with just the water rinse. Be careful not to drop the plate or scrub off
the
silicon.
6. Clean both the metal screen and the ceramic tile of the plate.
7. Rinse the plate with water and allow it to dry completely before replacing
it. If you have one available, you may use a hair dryer to gently dry
the
plate.
8. Replace the ceramic plate, making sure it is fully inserted and seated
securely
in
place.
9. Reassemble the unit and plug it into a properly grounded electrical outlet and turn it on.
To clean the needlepoint ionizer:
1. Turn the unit OFF via the power button and the power switch at the rear. Wait for the fan to stop spinning and then
unplug from the outlet.
2. Remove the fan grill cover from the front of the device by pulling it straight toward you. You may need to use your
fingernails or a flat object to get between the grill cover and the cabinet.
3. You can locate the needle-point ionizer easily by looking in front of the fan for two pieces of metallic wire.
4. Take a Q-tip or cotton swab dipped in isopropyl alcohol and use those to gently clean away any dust that may have
accumulated on the needle points.
5. While you have the fan grill cover off the unit, you may use a damp cloth to gently wipe clean the fan blade, and
rinse the fan grill cover with warm water. Make sure the grill cover is completely dry before reassembling the unit.
1
2
3
