6
CHARGEMASTER VCM
5201247 Rev. C
To mount the VCM Power Supply:
1. Locate the accessory kit provided with
the Chargemaster VCM.
2. Attach two mounting brackets, (see
Figure 2), to the VCM with M4 x 8
screws (provided in kit). Use mounting
bracket as a template to mark the two
mounting hole locations.
3. Drill two 0.201” diameter clearance
holes at marked locations.
4. Position mounting bracket’s screw holes
directly above drilled holes. Secure
with #10 screws, nuts and lock washers
(fasteners not supplied).
Grounding the Chargemaster VCM
CAUTION – Electrical Shock Hazard
It is essential that the machine frame, and all metal parts in the vicinity,
be grounded either through well-grounded electrical conduit or by heavy
copper wire to a water pipe.
All Chargemaster VCM power supplies must be properly grounded to ensure proper
operation and prevent shocks. A proper ground is also required to establish the
power supply electrical return and provide the return path for ion generation of the
attached bar or applicator.
1. The power supply should be connected to a grounded 3-terminal polarized
AC receptacle. Test the ground pin of the AC receptacle to assure proper
grounding.
2. Connect the green wire from ground terminal on the back of the power supply
to a well-driven ground rod. Do not ground to a hot water pipe.
3. Mount the unit using supplied mounting brackets to a well grounded metal
surface free of paint and / or any non-conductive surface treatment. The unit
is also grounded through the supplied mounting brackets.
Supplying Power to the Unit
1. Connect the AC line cord to the (IEC 320 input) connector on back of unit.
2. Plug the AC line cord into outlet. Verify that the voltage and frequency marked
on unit serial label match outlet power. If ON/OFF cycling is required, remote
switching MUST BE USED. Do not cycle the VCM Power Supply ON/OFF
through the AC input power line cord (see Section 6).
Figure 2. Mounting VCM Power Supply
