ITT Goulds Pumps ICM, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 40

WARNING Alignment:
Shaft alignment procedures must be followed to prevent catastrophic failure of drive
components or unintended contact of rotating parts. Follow coupling manufacturer's
coupling installation and operation procedures.
WARNING Before beginning any alignment procedure, make sure driver power is locked out. Fail-
ure to lock out driver power will result in serious physical injury.
CAUTION Piping:
Never draw piping into place by forcing at the flanged connections of the pump. This
may impose dangerous strains on the unit and cause misalignment between pump and
driver. Pipe strain will adversely effect the operation of the pump resulting in physical in-
jury and damage to the equipment.
WARNING Flanged Connections:
Use only fasteners of the proper size and material.
WARNING Replace all corroded fasteners.
WARNING Ensure all fasteners are properly tightened and there are no missing fasteners.
WARNING Startup and Operation:
When installing in a potentially explosive environment, please ensure that the motor is
properly certified.
WARNING Operating pump in reverse rotation may result in contact of metal parts, heat generation,
and breach of containment.
WARNING Lock out driver power to prevent accidental start-up and physical injury.
WARNING The impeller clearance setting procedure must be followed. Improperly setting the clear-
ance or not following any of the proper procedures can result in sparks, unexpected
heat generation and equipment damage.
WARNING If using a cartridge mechanical seal, the centering clips must be installed and set screws
loosened prior to setting impeller clearance. Failure to do so could result in sparks, heat
generation, and mechanical seal damage.
WARNING The coupling used in an ATEX classified environment must be properly certified and
must be constructed from a non-sparking material.
WARNING Never operate a pump without coupling guard properly installed. Personal injury will oc-
cur if pump is run without coupling guard.
WARNING Make sure to properly lubricate the bearings. Failure to do so may result in excess heat
generation, sparks, and / or premature failure.
CAUTION The mechanical seal used in an ATEX classified environment must be properly certified.
Prior to start up, ensure all points of potential leakage of process fluid to the work envi-
ronment are closed.
1.4 General precautions
6 Model ICM/ICMP Magnetic Drive Chemical Process Pump with Grease Bearing Lubrication Installation, Operation, and
Maintenance Manual