WARNING!
Risk of injury and poisoning due to hazardous or hot pumped
media!
–
Use personal protective equipment during all work on the pump.
–
Allow the pump to cool prior to work, if possible.
–
Ensure that the pump is pressure-free.
–
Empty the pump, flush if necessary and safely contain pumped
media and dispose of in an environmentally friendly manner.
n
Before removing the pump, always ensure that the pump has been taken out
of operation properly (
Chapter 6.4 ‘Putting out of operation’ on page 58
7.4.1 Remove pump
WARNING!
Slip hazard!
–
Clean up walkways if contaminated with leaked materials.
NOTICE!
Property damage due to improper transportation!
–
Do not lift the pump by its bearing case or gear case.
–
Ensure that the pump unit is not overly tensioned when it is
lifted.
–
Ensure that the lifting tackle cannot damage pipelines or units
when lifting, possibly use a lifting frame (
dimensional draw-
ings, operating instructions for pump system).
–
Make personal safety equipment available.
–
Observe statutory or other safety and accident prevention regu-
lations.
n
Pump switched off and safeguarded against being switched on again.
n
Pump pressure-free.
n
Pump completely emptied and rinsed.
n
Pump disconnected from the electrical system.
n
Inlet and outlet-side valves shut and safeguarded against unintentional
opening.
n
Pump cooled.
n
Coupling guard dismantled.
n
For coupling with spacer: Remove spacer.
Remove the pump from the system.
Please note:
Prerequisites:
Procedure:
Maintenance and repairs
Type SLH-4G, SLHS-4G
66
01/2016 JPB Rev. 5
