ITT Industries Flygt 3067, Установка, уход и техническое обслуживание

Страница: 13 / 24

13
OIL CHANGE
A check of the condition of the oil can show whether
there has been leakage. Note! Air/oil mixture can be
confused with water/oil mixture.
Insert a tube (or hose) into the oil hole. Cover the top
end of the tube and take up a little oil from the bottom.
Change the oil if it contains too much water, i.e. if it is
heavily emulsified (cream-like), or if the oil housing
contains free water. Check again one week after
changing the oil.
The oil housing may be under
pressure. Hold a rag over the oil
plug to prevent splatter.
1. Lay the pump on its side on a bench or over two
supports. Unscrew the oil housing screw (oil plug)
and drain the oil.
2. Fill with oil.
A paraffin oil with viscosity close to ISO VG15 is
recommended (e.g. Mobil Whiterex 309). The
pump is delivered from factory with this type of oil.
In applications where poisonous properties are of
less concern, a mineral oil with viscosity up to ISO
VG32 can be used.
3. Replace the O-rings under the oil housing screws
(plugs) with new ones.
10 Nm (7 ft lb)
▲ ▲ ▲ ▲ ▲
0,4 l (0,42 US quarts)