8
IB-P03
T
echnical
documenTaTion
Original notice - T1.10
N°
For (Motor output)
For (Motor port)
1
Motor coil (U-phase)
Motor port output
(U-phase)
2
Motor coil (V-phase)
Motor port output
(V-phase)
3
Hall signal
N/A
4
Motor coil (W-phase)
N/A
5
+12V
N/A
• Switching the motor output setting to motor port output, allows the use of the system in the same way as
remote output.
• The setting for “Motor output “ or “Motor port” can be switched with iCEP or PLC.
- With iCEP: Refer to «iCEP» user manual.
- With PLC: Refer to «Connection with PROFINET capable PLC» user manual - Paragraph «5. How to
change parameters».
• The available motor coils for motor port output are U-phase and W-phase. The outputs are fixed to Nch.
• The maximum output current value is 4A per motor in total of U-phase and W-phase.
The motor port output is fixed to “Nch open drain output ” and cannot be changed.
2
White
1
Brown
5
Grey
3
Blue
4
Black
N°
For
1
Tx+
2
Rx+
3
Tx-
4
Rx-
• Straight cable and cross cable can be used for LAN cable connecting IBs.
• The LAN cable should be category 5e or higher.
2 Green / White
1 Orange / White
4
Brown
3 Orange
Motor cable : M8 5 pin connector (female) - Cable length 220mm
LAN cable : M12 4 pin D-coded connector (female/male) - Cable length 930mm
