Page 3
Testing the Sensor
1.
Set the panel to the dealer sensor test
mode.
2.
Take the sensor and magnet to the desired
mounting location, making sure to line up
their alignment marks with each other.
3.
Trip the sensor by pulling the magnet
away from the sensor.
4.
Listen for interior siren beeps to indicate
how many rounds the panel receives from
the sensor. You should hear 6 to 8 beeps.
Note:
The Learn Mode Micro Door/Window Sen-
sor has a built-in power-saver feature that
turns on automatically when the sensor is
tripped more than once, within a 4-1/4
minute time period.
When this feature is on, the sensor trans-
mits only half the usual number of data
rounds when tripped. For example, you
may hear only up to 4 data rounds instead
of 6 to 8.
For accurate sensor test results, leave the
sensor undisturbed in the closed (non-
alarm) condition for 5 minutes before trip-
ping it for testing. This gives the sensor
enough time to turn off the feature.
Mounting the Sensor
After successful programming and testing are
completed, mount the sensor and magnet with
double-sided tape (included) as follows:
Note:
You must use 3 pieces of the double-sided
tape on the sensor as described in step 1,
to ensure the sensor does not move or
rock.
1.
Apply 3 of the four pieces of double-sided
tape to the bottom of the sensor and mount
the sensor at the desired location.
2.
Apply the remaining piece of double-sided
tape to the bottom of the magnet and