7
□40
3
4.
1
⌀12 H8
M8
36
36
8.
4
4
M6
4
80
120
10
13
24.2
22
28
15.8
36
36
8.
4
4
M6
4
Side for machining the M6 thread
Slot the guide carriage in its preassembled state onto the support profile that
you fitted the guiding Shafts to earlier.
Next, tighten the grub screws on the side alternately, making small adjustments
until there is no play between the Slide and guiding Shafts. Check the Slide
unit is free from play by pushing it along the entire length of the guiding Shafts
and make any adjustments that are necessary. Next, secure the position of the
Double-Bearing Unit from below using two Button-Head Screws M8.
Finally, install the End Cap and Lubricating Systems and Caps.
Slide Profile LRF 8 features two special grooves – one with an aperture width
of 10 mm, the other with an aperture width of 13 mm (see drawing). The groove
with the 13 mm aperture accommodates the play adjustment mechanism on
the slide. Play is adjusted by means of two threaded M6 through holes at the
side (see drawings) and two M6 grub screws.
Risk of mistaking the correct side for drilling!
