Itek GenPower 636, Руководство для стартапов

Страница: 5 / 15

3
EN
EN
6 hours
Installation & Initial Startup
NOTE: Before installation, please make sure nothing inside of package is damaged. To
protect your equipment from power failure, be sure that power switch must be kept in the
“ON” position. Following below steps to install your UPS unit.
Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air flow.
Please place the UPS away from other units at least 20 cm to avoid interference. Do NOT
operate the UPS where the temperature and humidity is outside the specific limits. (Please
check the specs for the limitations.)
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best
results, suggest to charge the battery at least 8 hours before
initial use. The unit charges its battery while connecting to
the utility.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the
power switch of UPS unit, then devices connected to the UPS will be protected by UPS
unit.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing
again the power switch.
CAUTION: NEVER connect a laser printer or scanner to the
UPS unit. This may cause the damage of the unit.