Locate the "12V OUT" section on the JS80 and open the orange
rubber flap.
Insert the Heavy Duty clamps into the "12V OUT" section as
per the image below.
Ensure that the vehicle's power loads are all off. Headlights,
radio, air conditioning and any other load.
Connect the Heavy Duty clamps to the corresponding battery
terminals. Positive to positive and negative to negative.
Press the start button located on the face of the JS80. See
image below. If connected correctly, the start button will
illuminate green.
Start the vehicle.
If the vehicle does not start, wait 30 seconds and repeat from
step 5 onward. Do not attempt more than five jump starts
within fifteen minutes.
When the vehicle starts, disconnect the JS80 and Heavy Duty
clamps.
Before connecting the JS80 to a vehicle's battery, ensure that the
battery and vehicle are 12V. The JS80 is not suitable for 24V+
vehicles. In most cases, the positive terminal will be red + and the
negative terminal will be black -.
Do not make any connections to carburetors, fuel lines or sheet
metal parts.
1.
2.
3.
4.
5.
6.
7.
8.
JS80
JUMP STARTING
START BUTTON
12V OUT & HEAVY DUTY CLAMPS
