
6
www.itec-audio.com
MICROPHONES
ITEC 5300 RADIO MICROPHONE SYSTEMS
3. Hand-held microphones
3.1 ITEC WM-5300
DISPLAY GROUP, CHANNEL AND BATTERY
IR DIODE (REAR)
LED BATTERY STATUS INDICATOR
ON/OFF SWITCH
POWER LOCK
3.1.2 Batteries
The WM-5300 is operated with 2 AA batteries. Please make sure that both batteries are always replaced by
new ones of the same type. When inserting the batteries, please pay attention to correct polarity. The status
of the battery is shown on the LCD display. The red LED battery status display also indicates the battery
status: when switching on, the display lights up for approximately 1 second and then goes out again. If this
indicator lights up permanently, this is a warning that signalises the low charging status of the battery.
3.1.1 Replacement of the capsule
The capsule can be unscrewed for replacement. The microphone is equipped with an electret capsule as
standard. A dynamic capsule is available upon request.
Battery change:
Unscrew the cap at the bottom end of the microphone and insert two new
batteries. Ensure correct polarity (minus pole resp. at the spring contact,
top and bottom)! Battery type: 2x Mignon “AA” 1.5V
Note:
Old batteries are special waste and must be disposed of accordingly.
Some batteries (mainly cheap products) may leak in case of longer sto-
rage, which may lead to corrosion and destruction of the battery contacts.
Use high-quality alkaline batteries from brand manufacturers; these also
have a longer service life.