v.081120
5
ENGLISH
ASSEMBLY
To disengage the cutting head from its shipping and storage position, push
down lightly on it and pull out the spring-loaded
Head locking button (I, fig.1)
on the right side below the motor. Turn it a quarter turn until the pin in the shaft
rests in the small groove to hold the button out.
To unlock the sliding action, partly unscrew the
Carriage slide lock screw (E,
fig.1)
, a
small knob at the right rear of the slide carriage.
To unlock the head angle (bevel) adjustment, loosen the
Slip-lock bevel
adjustment lever
(C, fig.1)
at rear of the saw. Lock it when the blade is tilted at
the desired angle.
To unlock the mitre angle adjustment, loosen the
Mitre clamp screw knob (J,
fig.1)
behind the right fence of the saw. Lock it when the blade is tilted at the
desired angle.
SAWDUST COLLECTION
You can operate this machine more safely and conveniently with a dust collector.
1. Connect a dust collection system hose (not included) to the nozzle on the back
of the metal guard.
2. If a dust collector is not available or convenient, use the included dust bag and
fit it to the dust nozzle at the back of the guard.
3. Whenever the dustbag is half full, remove it and zip open the bag at the bottom.
4. Clean out the sawdust completely.
HOLD-DOWN CLAMP
1. The hold down clamp included can be installed in either of the two holes
positioned just behind the fence at both the left and right ends.
2. Install the
Shaft (B, fig.2)
into the hole and then tighten the
Butterfly retention
screw (A, fig.2)
. Two grooves around the shaft allow the butterfly screw to
hold the shaft from moving vertically while allowing it to rotate for easy clamp
positioning.
3. You can adjust the height and position of the clamping arm according to the
thickness and shape of the workpiece with the knob at the back top.
4. Place the workpiece on the table tightly against the fence and slide it to the
desired cutting position.
5. Tighten the
Clamp knob (C, fig.2)
to secure the workpiece.
TABLE EXTENSIONS
Two
Table side extensions (B, fig.1)
are included with your saw to help support
longer pieces of material.
1. Each fits into two holes on the left or right side of the saw table.
2. On each side at the back of the table, a
Table extension retention screw
threads
in to hold the extensions in position.
MOUNTING AND REMOVING THE BLADE
WARNING
: Before replacing the saw blade always unplug the tool. Make sure
that the spindle speed, saw blade diameter, and saw blade bore match.
Only use sharp and undamaged saw blades. Cracked or bent saw blades must
be replaced immediately.
1. Lock the slide mechanism.
2. Lock the head of the machine in its highest position.
3. With the head of the machine in the upright position, rotate the lower saw blade
guard upward until exposing the fixing screw. Place the supplied wrench onto
the fixing screw.
!
