2
3
TECHNICAL DETAILS
ITEM
MAX PRESSURE
HOSE WORKING
TEMPERATURE (°C/°F)
HOSE CAPACITY
MATERIAL
I.D. (inch/mm)
LENGTH (m/ft)
028283
300Psi (20Bar)
-10 – 60°C (14 – 140°F)
Hybrid Polymer
3/8"/10
15/50
SAFETY PRECAUTIONS
GENERAL SAFETY RULES
WARNING:
Read and understand all instructions.
WARNING:
The warnings, cautions, and instructions discussed in this instruction manual cannot cover all
possible conditions or situations that could occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product but must be
supplied by the operator.
HOSE REEL SAFETY PRECAUTIONS
1. Use proper eye protection when assembling and using the hose reel.
2. Keep children away from the work area.
3. Personal injury and/or equipment damage may result if proper safety precautions are not observed.
4. Ensure that reel is properly installed before connecting input and output hoses.
5. Bleed fluid/gas pressure from system before servicing reel.
6. Before connecting reel to supply line ensure that pressure does not exceed maximum working
pressure rating of reel.
7. Remember, even low pressure is very dangerous and can cause personal injury or death.
8. If a leak occurs in the hose or reel, remove system pressure immediately.
9. Ensure that reel, hose, and equipment being service are properly grounded.
10. If reel ceases to unwind or rewind, remove system pressure immediately.
11. Do not pull or jerk on hose.
WARNING:
Exposure of skin directly to pressurized air or fluids could result in severe bodily injury.
INSTALLATION
1. Prior to mounting the hose reel, ensure that the supply line pressure does not exceed the maximum working
pressure of the hose reel.
2. Unpack and inspect reel for damage. Turn by hand to check for smooth operation. Check for completeness.
3. For overhead ceiling mounting: Install reel at most 10 ft/3 m above the floor.
4. You will need to purchase appropriate hardware for mounting your new reel.
i) The reel base has three 8.5 mm drilled holes for mounting on a suitable flat surface.
ii) Using the three holes in the base, mount the reel in the desired location. Be sure to use appropriate hardware
and tighten securely.
5. Apply Teflon tape or pipe sealant to supply line threads, attach to reel inlet and tighten. The other end of incoming
line can now be connected to desired supply source.
6. Apply Teflon tape or pipe sealant to outlet fitting on reel hose, then attach to desired tool or nozzle. Check
connection for leakage, also check hose reel for correct operation. See: Operation section.
7. If hose stopper adjustment is required, pull hose from reel and allow to latch at desired length. Loosen stopper
bolts and slide stopper to a position close to the hose guide. Tighten stopper bolts and unlatch the reel.
8. Double adjustment function: see the picture below. Adjusting the latch spring to left position can lock the
hose at any desired length. Adjust the latch spring to opposite position for a non-lock function, then hose
can be freely moved.