PAMSPAN501x G.SHDSL.bis EFM Gateway
8
1. DC IN:
Power Adapter Input
2. Reset Button:
Reset device to factory default setting
3. CID:
Connected to PC serial port for console
4. LAN:
Connected to Ethernet Port
5. DSL 1 to 4
Connected to loop 1 to 4
6. FG
Connected to ground wire
2.2 DSL Connectors Description
DSL Connectors on back of the unit, 2 RJ-11 sockets.
DSL
1 2
3 4
RJ-11 uses a 6P4C connector and cable. The cable has 4 wires and we are using them for
2 pairs of DSL connection.
2.3 Restore Factory Defaults/Reboot Button
Press the reset button to reset the PAMSPAN501X to its factory-default settings (the
default configuration file will be uploaded). If you forget your password or cannot access
the device, you will need to reset the device to the default settings. The procedure is as
follows:
1. Power off the modem.
2. Press the reset default button.
3. Power on the Modem, and check the front panel of the modem.
4. When the “CPE LED” blinks rapidly, release the reset button.
(If you press the button for too long, the configuration file recall won't work. This is to
prevent the user from holding the button continuously)
5. The factory defaults should now be recalled. (This is called a "one-time recall")
Pin 1 Not used.
Pin 2 Tip for DSL pair 2 or 4.
Pin 3 Tip for DSL pair 1 or 3
Pin 4 Ring for DSL pair 1 or 3
Pin 5 Ring for DSL pair 2 or 4
Pin 6 Not used.
1
2
3
4
5
6
