The pushbutton panels with the three buttons control each of the taps. The first two buttons control
the dispensing of the preset measures (button 1 dispenses the sample measure and button 2
dispenses the normal measure) whilst button 3 is used for continuous dispensing and for setting the
measures.
1 -
SAMPLE MEASURE
2 -
NORMAL MEASURE
3 -
CONTINUOUS DISPENSING / PROGRAMMING
GREEN Leds
PUSHBUTTON CONTROLS
BUTTON
1
Button 3 is used to set the measures for buttons 1 and 2 by following the procedure described below
ENTER PROGRAMMING MODE
1 - Press and hold button 3 until all the green LEDs remain lit on the control panel in question, then
release it (the LED for button 3 will continue flashing but the other two remain lit without flashing).
SET THE MEASURE FOR BUTTON -1-
2 - Press and release button 1; when the required measure is reached, press and release button 1
again (the LED for button 1 will turn off).
SET THE MEASURE FOR BUTTON -2-
3 - The procedure for button 2 is the same as for button 1
EXIT PROGRAMMING MODE
4 - Press and hold button 3 until the flashing green LED switches off, then release it: the required
measures for buttons 1 and 2 have now been stored in the dispenser's memory.
:
.
To dispense a sample measure into a glass, simply press and release button 1. The electronics
stop the flow when the pre-set measure has been reached. Follow the same procedure with
button 2 to pour a normal measure.
Button 3 is used for manual dispensing and programming.
To pour a measure that is not a pre-set amount, simply press and release button 3. Wait for the
required amount to be dispensed and then press and release button 3 again.
.6
BUTTON
2
BUTTON
3
