iSystem IOM6 CAN/LIN, Руководство пользователя

Страница: 17 / 20

Accessories
The following accessories are available to connect the IOM6 CAN/LIN Accessory to the target
CAN, CAN-FD or LIN interface(s).
Ordering Code Description
IC57040-CAN-DB9 1m CAN cable DB9
IC57040-CAN-JACK CAN cable banana jacks
IC57040-CAN-PIN CAN cable pin wires
IC57040-CAN-T CAN BUS T adapter
IC57040-LIN-JACK LIN cable banana jacks
IC57040-LIN-PIN LIN cable pin wires
BB-FNET-100 1 m FNet Cable (for use with AOM accessories)
BB-FNET-300 3 m FNet Cable (for use with AOM accessories)
BB-FNET-500 5 m FNet Cable (for use with AOM accessories)
The topology of a CAN network is shown in the CAN BUS T adapter chapter. The ends of the
network require termination using a 120 Ohm impedance, connected between the CAN_H and
CAN_L signals.
iSYSTEM accessories provide the termination impedance via a switch on the DB9 connector. In
the default switch position the termination impedance is not connected.
If the IOM6 CAN/LIN is connected at one of the ends of the network (node A or D in the
diagram above) the 120 Ohm termination impedance can be enabled using the switch on the
iSYSTEM connector accessories. If connected to the CAN bus at the position of nodes B and C,
no termination is required.
Find more information on www.isystem.com or contact sales@isystem.com . To reach
for technical support please visit www.isystem.com/support .