LCN-UT
Installation guide
Local Control Network - building controls in perfection
2
Included in delivery:
LCN-UT, 3 antennas & 2 transponders (1 ZTK & 1 ZTS).
Connection
The LCN-UT is for connecting to the I-port of all LCN Bus modules with firmware 0E....
(Jan. 2005) or after. The supply line can be extended up to 50m by using 2 LCN-IV´s.
The following peripheries can be used on the I-port parallel to the LCN-UT: LCN-GBL, -
RR, -ULT, -GT2, -GT4D, -GT10D, -GT3L, max. 1 further -EFS, but no more than 5 I-
periphery devices on one I-port at the same time.
Operating the LCN-IV as impulse counter/counter input is not possible!
Additionally, the LCN-UT needs a power supply of 10-18V DC. for this, an LCN power supp-
ly like the LCN-NH12 or LCN-NU16 can be used.
Because the LCN-UT is electrically isolated from its LCN module, several LCN-UT modules
can use the same power supply.
Function
The LCN-UT must be activated with the LCN-PRO under
Ports > I-port.
Then
the LCN module will send the transponder code to the LCN Bus when the antenna is
approached. It can be displayed on the Bus monitor (LCN-PRO: key <F8>) and evalua-
ted with the LCN-GVS for access control.
I
mportant:
®
