MEASUREMENT AND ASSEMBLY MANUAL
Instruction validity: as of 1 August 2013
9
brown = phase/neutral conductor,
yellow-green = ground.
End switches for a motor installed in the winding drum are not pre-set, therefore the roller blind opening/closing positions
are completely random. Motor end switches can be set up in various methods, according to the type and mark of the motor
used. Instructions for the end switch programming and setting are specified in a separate manual.
To set up the end positions, first turn on the motor to roll the roller blind down, set the required locking position. Then s et
the upper position (full draw). In both cases, the adjustment of both the open and closed positions of the roller blind must
not cause loading of the lower rail or fabric.
Prior to final connection and operation, check if the system works properly. Operate the roller blind for at least two
consecutive cycles and check the function of thermal disconnection after 4 minutes of continuous operation. To provide for
proper function of the roller blind, check if the winding drum is perfectly level after installation. Following the roller blind
installation, check if the end user understands the method of operation of the roller blind, and give this manual to the user
for future reference.
NOTE: There is a risk of compression in case a hand is trapped between the fabric and the upper box during the
roller blind updrawing. Before operating the roller blind, move your hands outside of the movement range to
prevent compression. Vibrations or excessive noise indicate damage or faulty installation of the roller blind.
8.2 TESTING
To provide for proper function of the roller blind, check if the winding drum is perfectly level after installation.
Following the roller blind installation, check if the end user understands the method of operation of the roller blind, and give
this manual to the user for future reference.
8.3 REMOVAL OF WINDING DRUM FOR MAINTENANCE
NOTE: Prior to commencing the steps described below, disconnect the motor cables from the main switch to prevent
inadvertent motor actuating. The box consists of fixed part (2) and removable cover (3). If it is necessary to remove the
drum, first remove two screws
– one on each side – and remove the removable part of the box (3). If the motor used has a
mechanical end switch, the switches can be activated by a screwdriver through tow holes (4) pre-drilled in the box (on
request). Specify the access position (from rear or front) when ordering.
The roller blind components may vary in accordance with the roller blind dimensions and the motor type. The winding drum
is attached to the side boards as follows:
