MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 1. 9. 2014
3
INSPECTION:
•
We recommend inspecting all the parts of the goods after the delivery to prevent any problems before assembly.
Any defects or comments concerning the assembly or blinds must be notified to the manufacturer
ASSEMBLY
•
remove the upper profile of the blind
•
never expand the blind before assembly
•
on the blind in the window wing check that the dimension corresponds to the width of the window
•
check that the control mechanism is located on the correct side; it is possible to move the control mechanism, if
necessary, but only after prior training
•
depending on the depth and form of the glazing bar, support the blind using pads
•
screw the blind to the window frame using two or four screws according to the size of the blind for plastic windows,
although only into the glazing bar to prevent damage to the window ring; for the width of 80 cm or more, it is possible to
secure with a screw in the middle of the blind - for plastic, then again only into the glazing bar
•
drill upwards into the lower part of the glazing bar and drill holes for the tightening pins for the leading nylon which pass
in the side boards, then tighten the redundant ends and insert the remaining ends of the nylon into the upper profile of
the blind.
•
click the cover bar with side covers into the upper basic profile, for blinds with pads insert from upwards between the
window frame and the basic upper profile; along the whole width, further pads are removed after the clicking of the
upper cover bar as this prevents the blind from springing
•
fix the clamping piece of the chain; for plastic windows, again only into the glazing bar,
•
check the function of the blind
If the form or the size of the glazing bar does not enable one to drill holes for the tightening pins into the glazing bar from
upwards, choose the option of drilling the holes for pins into the face of the glazing bar. In this case, take care not to
damage the glass with the drill. It is important to measure the correct depth for the drilling! The client must be informed in
advance of this form of assembly and consent in writing to the handing over protocol. In each case, ensure the full
functionality of the blind and the window.
ATTENTION.
During assembly it is necessary to place the blind in the window when it is lifted up; mark the position of the screws on the
window wing, fit the blind and then lower it. Each manipulation of the blind before assembly (if necessary) is only to be
done in the horizontal position! Any other manipulation is forbidden and claims for such damaged blinds will not be
accepted!
ATTENTION!
Pursuant to the EN 13120:2014 standard, window blinds shall be installed in accordance with the
following instructions:
