Isotherm 3160BB1C, Инструкция по эксплуатации

Страница: 16 / 24

Manuale d’uso – User’s Manual
CG 23072012 Ver 1.2 Pag.
16
Maintenance
Isotherm refrigerators have an hermetic cooling
system that requires no maintenance nor filling of
refrigerant. The device can be left on the boat
during winter time (if the temperature drops
below 0, the compressor may not start).
Maintenance, not less than once a year, may be
reduced solely to clean the dust from the
condenser. Use a soft brush and not sharp
instruments.
Leave the inside of the refrigerator clean and dry.
Clean the condensate drain and check it is not
clogged up.
Leave the drawers of the fridge / freezer ajar
during the period of non use of the apparatus to
allow adequate ventilation inside the
compartments; make sure the device is switched
off to avoid waste of power caused by turning on
LED lighting.
Defrost Cycle
The defrost cycle is to convey hot gas by-passed
through the electric valve inside the evaporating
battery in order to melt the accumulated ice,
collecting the resulting condensate in a special
tank where it will evaporate.
The operation is as follows:
- Every 6 hours if the doors are opened;
- Every 12 hours if the doors are NOT opened.
During this cycle the compressor can work at
times on the basis of the defrost program.
TECHNICAL INFORMATION
Voltage 115V/60Hz o 230V/50Hz
Max Consumption
Watt 180W (115V/230V)
Compressor Type Danfoss TTY5F (115V)
Danfoss TLES5.7FT.3 (230V)
Refrigerant R134a, 130gr.