Continue wrapping the assembled Misting Tube around the complete circumference of umbrella. Position
a Tee with Nozzle at the end of each umbrella rib.
Place one of the Umbrella Clips provided over the Misting Tube about 1-2 inches on the left and the right
side of each Tee with Nozzle and adjust Nozzles at 45 degree angle to the ground and away from the
covered portion of the umbrella.
Use one or two Umbrella Clips to fasten the Misting Tube onto umbrella fabric between the Nozzles on the
rib ends to secure the Misting Tube in place.
Repeat the previous steps until each Tee and Nozzle on the Misting Tube has an Umbrella Clip on either
side(with the exception of the last Nozzle fitting)
NOTE: Be sure to stretch the Misting Tube tight during installation to prevent sagging.
Step 4: Nozzle Alignment
If needed, CAREFULLY align the Nozzles so that they are all facing the same direction. We suggest that
they are mounted at a 45°degree angle, but you may decide on a different angle as your personal
preference.
Turn on the water and enjoy the refreshingly cool mist provided by your IslandMist Cooling System &
Umbrella Kit
Note: When you first turn the system on, it is completely normal for water to leak around the fittings. The
fittings will re-seal themselves within the first 2-3 minutes of use.
RECOMMENDED MAINTENANCE:
Please review these hints to keep your IslandMist misting system operational and prevent clogging the Nozzles:
1.
Draining Water from your system:
When your system is not in use, drain all water from the system.
2.
Cleaning the Nozzles:
Periodically clean all nozzles by soaking them in a solution of CLR, or similar calcium and iron remover.
3.
Periodically remove all nozzles and flush the system by running water through it for 4 or 5 minutes.
