Note:
That the material will progressively harden with each pass.
Note:
If you are working with stainless steel it is important to finish the job in a few passes.
Because the work hardens and it progressively harden after each pass.
CONICAL BENDING
To make the conic bending operation in the machine, the down roll must oblique position.
Please follow these instructions step by step.
Down roll must be bottom position
At behind the machine, near the roll there must be a cover in it, please takeoff this cover.
Roll must be oblique position
Opening roll must be oblique position too to make this roll must be up position
To adjust this roll please take off the connections under the cover and it must be get into oblique
position ( like down rollers )
Now two rolls are oblique position and machine is ready for conic bending
Please replace the sheet this ready ( for conic bending ) machine and replace the conic support bars
behind the sheet now you can make conical bending.
Attention :
Be sure to clean any oil or grease put on the rolls
before operation. If don’t work lubrication or lubrication deficiency
we don’t responsible for lubrication deficiency or don’t work
damages at last.
Note:
When bending conical the overall max. thickness capacity decreases by 25 %
Note:
When cone bending, the thickness and width capacities of the machine are reduced.
Check with the distributor or manufacturer for your requirements.
