• SEEK
►
will seek up to the next available station based on signal strength.
•
◄
SEEK will seek down to the next available station based on signal strength.
• Storing stations - Tune to the desired station. Press Preset 1-6 and hold for
approximately 3 seconds until PR SAVED is displayed. To recall a preset station
press the desired Preset button. HD and analog stations can be stored. HD Radio
stations are indicated by HD1, HD2 or HD3 following the station frequency.
• TEXT will change the display to show artist or song title if available.
Note for vehicles with a diversity antenna: In the large 20-pin main power and audio connector
pin 13 is the amplified antenna turn on wire. This wire must be cut from the original connector
and attached to pin 11, the radio acc12v wire. During SAT emulation this circuit is not
energized by the radio. It must be energized for HD radio signal. The circuits can be verified with
a volt meter.
ISGM575
• The HDRT should be connected to Device 2.
• Press the BAND button until XM is displayed. Turn the rotary TUNE KNOB until HD
RADIO is displayed. Wait 4 seconds and the source will be automatically be
selected. Pressing the BAND button after HD Radio has been selected will switch
between HD-FM and HD-AM.
• Tune up - turn the rotary TUNE KNOB to the right to move up one frequency at
a time.
• Tune down - turn the rotary TUNE KNOB to the left to move down one
frequency at a time.
• SEEK
►
will seek up to the next available station based on signal strength.
•
◄
SEEK will seek down to the next available station based on signal strength.
• Storing stations - Tune to the desired station. Press Preset 1-6 and hold for
approximately 3 seconds until a beep is heard. To recall a preset station press
