6. SCALE SETTINGS
6.1
PRE-TARE :
With an empty pan Press Zero +
TARE - “P-tArE” will flash on the
display. Now press the Zero key
once and the display shows all
“000.000”. Now Enter a value
(ex.200g), using Tare & Mode
keys. Exit the setup menu by
pressing the Zero/Enter key until
the scale comes in weighing
mode. The Pre-set Tare will be
displayed as a negative value (no
weight on the pan). Note: To
clear the Pre-set Tare value, press
TARE with the pan empty it will remove it temporarily and to remove the
Pre Tare value permanently from the memory you have to again go in to
the settings and make the pre-tare value “000.000” using Tare & Mode
keys.
6.2
AUTO ZERO :
Press Zero+TARE button The
display will show A0 – X (0, 1, 2,
3).This is the auto zero setting.
You can select the value using
the TARE button. 3 mean 3d in d
mode and 3e in e mode
(remember d =e/10 and e is the
scale interval. That is e = 2gms and d = 0.2gms) similarly for 3, in d=e/10
mode it will auto zero upto 0.6gms, and in e mode it will auto zero upto 06
gms. Default setting of Auto-Zero mode is 3d.
ITA Series – Table Top Precision Weighing Balance
ITA Series – Table Top Precision Weighing Balance
6
7
6.3 LED GLOW :
The display GLOW strength can
be increased or decreased
depending upon the user
requirement. Increasing the
GLOW of the display will effect
the Battery back up time, and
the battery life. The GLOW
setting is set to minimum by
Default. If the user wants to
increase the GLOW of the
display, it can be done as follows:
When the scale is in the weighing
mode, While pressing the ZERO
button, press the TARE button. The display will show “P-TARE” Now press
the Zero button three times so that the display shows “GLOW 0”. 0 means
the GLOW mode is currently set to Low. Now press the TARE button, and
you will notice the GLOW of the display is increased to 1 and 2 level. After
selecting the level press the ZERO button, until the display comes back to
the weighing mode.
6.4 SLEEP MODE
:
The scale has a power saving mode
called the SLEEP MODE. In this
mode, if the scale is idle for one
minute, that is there is no weighing
being done, the display will simply
show the decimal point of the right
most digit on the display.
Whenever any weight is kept, the
scale will automatically come out of the SLEEP MODE and start displaying
the weight.
