ISGM LP-700, Руководство пользователя, Страница: 9 / 20

9
Boosting power using an additional power supply unit and a power injector
Always ensure that power is boosted after every 56 pixels in a daisy-
chain. An LP-700 Power Injector (P/N 83062008) can be used to
supply boost power from an additional power supply unit (PSU - P/N
83061701) and connect two LP-700 LED Pixel strips without splicing
or crimping; the DMX control signal continues unbroken to each fixture
in a daisy chain. A 3-metre (10 ft) maximum cabled-distance between
the power supply and the first LED PIxel it supplies power to applies.
Cutting or splicing strips
Strips can be cut to the required length, but if the system
is installed outdoors, ensure that any exposed cable ends
are sealed using a hot glue gun, or similar IP65-rated
cable sealing method. Splicing strips of LP-700 LED Pixels
together must be carried out by a qualified electrician. The arrow
on the back of each LP-700 LED Pixel indicates the direction
away from the power supply unit.
When and patching, splicing or crimping power and control
cables it is important to note that the LP-700 LED Pixel uses
unbalanced DMX. DMX control only uses pins 1 and 3 of the XLR
connectors. The pinout of the male connectors on the LP-700
LED Pixel strips are shown here in the illustration.