6
Charging the battery
For optimal condition and capacity of the battery, we recommend charging the battery at room temperature.
For safety reasons, there should be no flammable material in the area whilst charging.
To charge the battery:
1. Open the cover of the charging plug.
2. Connect the cable of the supplied charger.
3. Then insert the plug of the charger into the socket.
4. Remove the key of the EuroScooter2 to prevent use during loading.
5. Depending on the state of the battery, the charging time is about 4 to 5 hours.
6. When the green light comes on, the battery is fully charged.
7. You should disconnect the plug from the socket only when the battery is fully charged.
8. Then pull the charging plug of the batteries out of the EuroScooter2 and close the cover
Replacing the batteries
When the battery life has run out and your range significantly decreases, you can prepare the vehicle for battery replacement.
Safely pack and secure the EuroScooter2 on a pallet transport and send it to ISEL for service. The replacement of the batteries by the
customer is not provided for due to necessary ISEL electronic expertise which is required to avoid errors. After the battery
replacement a full charge of the batteries is required.
Cleaning
The frame of the EuroScooter2 can be wiped with a damp cloth. For larger dirty areas, you can use a mild detergent. The wheels can
be cleaned with a damp, plastic haired brush (not a steel brush!). The seat and handles can be cleaned with mild soap and water.
Do not use a high pressure or steam cleaner!
Inspection
After 200 operating hours, or, after a period of 3 months, the EuroScooter2 must be inspected. Inspect the brakes, lighting and
bolting on the wheels. In addition, check the tread depth of the tires. Depth must be at least 1 mm. Worn tires or defective parts
must be replaced. Also, check the function of the parking brake. With a firmly applied parking brake, the vehicle should not be able
to drive away by the driver.
Brakes
The hydraulic disc brake enables safe braking due to its even force distribution. The brake pads should be checked every 3 months
and be the minimum of 1 mm in thickness. Hydraulic disc brakes are basically very maintenance-free, but if the closed oil system is
leaking or the pressure point of the brake is lost, then it is it is necessary to do maintenance on the disk brake. This maintenance
should be done to the system by ISEL. A customer service is not provided, as errors in oil and settings can be made.
Repair and maintenance instructions
It is recommended to have the EuroScooter2 inspected by an ISEL specialist at least once a year. In case of faults or defects, the
EuroScooter2 must be brought immediately to an ISEL service point for repair. The replacement safety-related parts (especially
frame, brakes, lights, handlebars, front fork and drive) must be performed by an ISEL specialist.
If you want to replace the parts yourself, you are responsible for any damage or injury caused by not correctly assembling any
section. If you use only original spare parts, you can order them directly from ISEL.
Disposal
If you want to dispose your EuroScooter2, please contact your ISEL dealer or your local waste disposal company.
The vehicle should be disposed of in accordance to the regulations in force at your place of residence. The batteries should be sent
back to ISEL.
Содержание 440703
Страница 1: ...1 OPERATIONS MANUAL ...
