Iseki SRE2600X, Инструкция по эксплуатации

Страница: 58 / 92

GB
58 SRE2600X
Help in case of malfunction
Fault code Cause Remedy
CN017: Cal: signal
weak
Fault during the calibration:
■
Loop signal too weak
■
No loop signal
■
The boundary cable is
faulty.
■
Place the appliance at the pre-
scribed calibrating position; align
precisely at right angles.
■
Check the power source of the base
station. Disconnect and reconnect
the transformer.
■
Check the boundary cable for dam-
age.
CN018: Cal: Colli-
sion
Fault during the calibration:
■
The appliance has
bumped into an obstacle.
Remove the obstacle.
CN038: Battery
The rechargeable battery is
flat:
■
Loop of the boundary
cable is too long, too
many islands. Correct the location of the boundary
cable.
■
When charging, no con-
tact to the charging con-
tacts
■
Clean the charging contacts.
■
Place the appliance in the base sta-
tion and check that the charging
contacts make contact.
■
Have the charging contacts checked
and replaced by a service centre of
the manufacturer.
■
Obstacles close to the
base station Remove the obstacles.
■
The appliance has got
stuck. Place the appliance on the free, desig-
nated grass surface.
■
The appliance does not
find the base station.
■
Check the boundary cable for dam-
age.
■
Have the boundary cable repaired
by a service centre of the manufac-
turer.
■
The rechargeable battery
is depleted. Have the rechargeable battery replaced
by a service centre of the manufacturer.
■
The charging electronics
are faulty. Have the charging electronics checked
by a service centre of the manufacturer.
CN099: Recov escape
Automatic fault rectification
not possible
■
Manually acknowledge the malfunc-
tion message.
■
If the fault reoccurs: Have the appli-
ance checked by a service centre of
the manufacturer.