iseg THQ Desktop, Техническая документация инструкция

Страница: 23 / 41

Command Computer HV Device
Read device identifikation #1<CR><LF> 600000 ; 2.01 ; 3000 ; 205 <CR><LF>
(serial number ; firmware ; V
nom
; I
nom
)
Read measured voltage
channel 1 V
meas
U1<CR><LF> {Measured voltage}<CR><LF> [V]
Read measured current
channel 1 I
meas
I1<CR><LF> {Measured current}<CR><LF> [A]
Read set voltage
channel 1 V
set
D1<CR><LF> {Set Voltage}<CR><LF> [V]
Write set voltage
channel 1
(Channel goes into USB
mode) V
set
D1={voltage}<CR><LF> 0 ≤ voltage ≤ V
nom
[V]
Read set current
channel 1 I
set
C1<CR><LF> {Set current}<CR><LF> [A]
Write set current
channel 1 I
set
C1={current}<CR><LF> 0 < Current ≤ I
nom
[A]
Read Polarity channel 1 P1<CR><LF> {+|-}<CR><LF> positive or negative polarity
Write Polarity channel 1 P1={+|-}<CR><LF> set positive or negative for EPU
only
Read Autostart channel 1 A1<CR><LF> {1|0}<CR><LF> 1= USB active after power-on
0= Local Mode after power-on
Write Autostart channel 1 A1={1|0}<CR><LF> 1= USB active after power-on
0= Local Mode after power-on
Set double echo
(see compatibility mode) E1={1|2}<CR><LF> E1=1<CR><LF>
E1=2<CR><LF> single Echo (ex works)
double Echo (as in
9.6 Compatibility with THQ 1.xx)
Read device status
channel 1 S1<CR><LF> HL<CR><LF> hex code ➜ see 9.7 Device status
Read KILL function
channel 1 T1<CR><LF> {1|0}<CR><LF> 1= KILL enabled
0= KILL disabled
Write KILL function
channel 1
(computer control only) T1={1|0}<CR><LF> 1= enable KILL (and clear Trip)
0= disable KILL (and clear Trip)
Notes:
Other channels can be used in devices with two or three high voltage channels by replacing channel ‘1’ with ‘2’ or ‘3’,
e. g.: “#1” “#2”.
Table 6: Command descriptions
THQ Systems - CONFIGURABLE AC/DC LABORATORY HV SUPPLY | Last modified on: 2022-04-21 | www.iseg-hv.com 23/41