3.2.5 Channel Details
To change the set values of a channel or to monitor one single channel with larger digits, the Channel screen needs to be
entered. This can be done in Main screen by turning the rotary encoder until the wished channel is marked and then
pressing the rotary encoder button to select it. A screen similar to the following will be shown.
back to Main screen with
switch screen between set and measured values with
left button
right button
3.2.6 Editing Channel Set Values
In the channel screen it is possible to edit set values of the selected channel. This is done by marking current or voltage
value by turning rotary encoder and applying this by pressing the rotary encoder button. An edit field beneath the shown
values will be displayed. The edit value is shown with a digit hi-lighted by a cursor. A short press on the rotary encoder
button and the cursor will jump to the next lower digit. Turning the rotary encoder changes the selected value in the
resolution of the digit. Submit and apply of the edit value is done by pressing and holding the rotary encoder button for
more than one second. There are two modes of editing available: manual and auto-apply. In manual mode, the edited
value is not accepted until the user applied it with pressing and holding the rotary encoder button. In auto-apply mode
the edit value is immediately accepted as turning the rotary encoder.
cancel edit with left button
selected screen: set or measurements
selected channel with its running and regulation
state (constant voltage / constant current)
set (orange) or measured (white) values of voltage
and current of the selected channel
switch edit mode with right button:
manual or auto-apply mode
NHS – NIM standard High Voltage Power Supply | Last changed on: 16.01.2020 |
www.iseg-hv.com
17/30
edit field
