iseg EHS 40100p, Техническая документация инструкция

Страница: 17 / 42

2.3 Options
OPTIONS OPTION CODE EXAMPLE ITEM CODE HEX CODING
POLARITY Positive: x = p ,
Negative x = n
EHS 82 05 p
VERY LOW NOISE (only EHS CG Series) VLN 010
SINGLE CHANNEL INHIBIT - down ID 400
SINGLE CHANNEL INHIBIT - up IU 800
NEGATED LOGIC INHIBIT ID, IU N 80
VOLTAGE CORRECTION by TEMPERATURE VCT 008
LOWER TEMPERATURE COEFFICIENT TC T10 004
ACTIVE SAFETY LOOP SLA 001
INTERNALLY POWERED SAFETY LOOP SLP 002
ONLY ONE CURRENT RAGE FOR HIGH
PRECISION MODULES 1CR 020
200 V ISOLATION FOR FLOATING GND F02 100
2,000 V ISOLATION FOR FLOATING GND F20 200
LOWER OUTPUT CURRENT (1 L (I
nom
= 100 μA) –
Notes:
1) Requires option „1CR“.
Table 9: Technical data: Options and order information
3 Handling
3.1 Connection
The supply voltages and the CAN interface are connected to the module via a 96-pin connector on the rear side of the module.
The physical address of the module, determined by the slot position in the crate, is also accessible via this connector
Modules and crate controllers with different settings of bit rate do not work on the same CAN-Line.
INFORMATION
INFORMATION
Note: For proper operation the module must be configured with the correct CAN bitrate, which meets the
configuration of the crate controller, the module will be used with. The delivery condition is shown on the
modules typeplate (side plate of the module).
Typically newer iseg crate controllers (CC24, CC23, CC238) are delivered with 250kBits/s standard. Wiener
M-POD Controller and older iseg hardware is set on 125 kBit/s standard bitrate.
INFORMATION
INFORMATION
Note: EHS modules with Common Floating Ground (CFG) will be delivered with a jumper, which connects the
module-GND with the crate-GND. To operate in CFG configuration the jumper (CG-CFG) on the module back
must be removed. (
see: Dimensional drawing )
EHS High Voltage Power Supply series | Last changed on: 16.01.2020 |
www.iseg-hv.com
17/42