ISDT ESC70, Руководство пользователя

Страница: 6 / 11

设置电子调速器
1.
无开关模块校准油门行程
若未安装电子开关模块（ Switch ）则电子调速器通电后即处于开机状态。
开始油门行程校准前请将遥控器油门通道的各项参数调到默认值并将油门通道的中点微调设置为 0 。
注：必须严格按照下列顺序进行油门校准，否则否则可能出现遥控器油门方向与车辆实际运行方向相反的情况。
校准完成后运行模式默认为正反转带刹车模式。
ESC Setup
1. Calibrate the throttle stroke without two in one switch module
If the electronic switch module (Switch) is not equipped, The electronic speed controller will be TURNED ON when it detects the battery.
2. Before Calibrate throttle range, ensure the esc is connected to your receiver in channel 2 (CH2) , fully charged battery is connected and a well Calibrated Radio Ready.
3. Please adjust the throttle channel throttle/brake EPA parameters on your remote control to the default values and the midpoint to 0.
Note: The throttle must be calibrated in strict accordance with the following sequence, otherwise the car may engage laggy response and may run reversely with the remote control
directives.