IRT Communications DMM-4880, Инструкция по эксплуатации

Страница: 10 / 16

DMM ‐ 4880 & DMX ‐ 4880 Instruction Book Revision 0
www.irtelectronics.com Page 10 of 16 4880 ‐ DMM_4880 ‐ DMX_ib_Rev0.doc
DMX ‐ 4880:
STM ‐ 4 Input:
The optical STM ‐ 4 input port on the rear of the unit is an SC/PC (standard) optical connector for use with single
mode fibre.
The standard optical detector used is a PIN detector and is rated for an optical input between
‐ 3dBm and ‐ 18dBm.
If the input signal strength is greater than ‐ 3dBm an optical attenuator (5 or 10 dB recommended) must be used to
avoid overdriving the detector.
STM ‐ 1 Outputs:
Four STM ‐ 1 electrical outputs are provided as 75 Ω output BNC connectors. Each STM ‐ 1 output is equivalent to the
corresponding STM ‐ 1 electrical input on the matching DMM ‐ 4880.
Alarm Outputs:
Two relay alarm output states are provided via a phoenix style 3 ‐ pin plug. Pin 3 is designated as Major, pin 2 is
designated as Minor, and pin 1 is ground. Both alarms are referenced to ground.
Alarm conditions are as follows:
Major switch to Open Circuit on no valid STM ‐ 4 input present;
Minor switch to Open Circuit on no valid output STM ‐ 1 streams present, or
no valid STM ‐ 4 input present.
Both Major and Minor alarms switch to Open Circuit on power failure.
1 GND
2 MINOR
3 MAJOR
STM-1 O/P 3
ALARM O/P
DMX-4880
Rear Assembly Connections
STM-4 I/P
STM-1 O/P 2
SK 9 OUT3
PL4
SK10
SK 4 OUT4
SK 8 OUT1
SK3 OUT2
PL3
1
2
3
1-GND
2-MINOR
3–MAJOR
STM-1 O/P 1
STM-1 O/P 4
IRT
Communications
www.irtcommunications.com