Diagrams of Athena Horizontal
Pipe Centres
Fix Brackets
3
PLEASE NOTE:
It is essential that all brackets are
level to ensure a vertical alignment for
connecting the pipework.
Hang Radiator & Commission
4
Please Note:
In accordance with Part L1 2006 of the Building Regulations
and BS7593:1992 code of practice for the treatment of hot
water and central heating systems, we strongly recommend
flushing the heating system post installation of new radiators
and then adding the correct quantity and type of inhibitor
for use with your radiator and system to prevent corrosion.
Damage caused to systems not protected by a suitable
inhibitor will not be covered by manufacturer’s guarantee.
Unpack & Inspect
1
You should have:
• 1 Radiator
• 4 Wall bracket Nipples
• 4 Wall brackets Sleeves
• 4 Grub Screws
• 1 Airvent
• 1 Blanking Plug
You will need:
• Tape measure
• Electric drill
• Suitable drill bit and plugs
• Spirit level
Contents
2
The Radiator Company prides itself on selecting products
from manufacturers who exercise tight quality control
measures.
We only select models with excellent standards of welding
and brazing, as well as high quality finishes.
All of our products are well packaged and should reach
you in perfect condition. Just in case however, we offer a
minimum 5-year no quibble guarantee for all radiators and
towel rails.
The Radiator Company must be notified of any shortages or
damage within 28 days of delivery.
For further information please see
terms and conditions on back page.
Pipe centres left to right
width minus 70mm
Pipe centres from wall
45mm to 53mm
Depth from wall
67mm to 75mm
1.
Insert bracket nipples into threaded holes on the back of
the radiator.
2.
The fixing positions for the two top brackets are measured
down 77.5mm from the top of the radiator and 35mm
in from the edges of the radiator. Mark the positions on
the wall and hold up your radiator to check the positions.
3.
Ensure the markings are level, and using a suitable drill bit
and plugs, fix the top two bracket sleeves to the wall.
4.
For accuracy, we suggest hanging the radiator on the top
two brackets, then marking the bottom bracket positions.
5.
Remove the radiator off the wall and fix the bottom two
brackets to the wall.
6.
Hold up the radiator to the wall and slot the four bracket
nipples into the bracket sleeves.
7.
Use the provided grub screws to secure the radiator by
inserting and tightening on the side of the brackets.
35
77.5
Bracket Positions
35
77.5
77.5
35
77.5
35
67-75
45-53
