IRP U-SHAPE Series, Руководство пользователя

Страница: 24 / 38

Page 24
AIR CONDITIONER CONTROLS
Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its
functions then follow the symbol for the functions you desire.
The air conditioner can be controlled by the remote or the
control panel.
Unit Control Panel
Operation Buttons
ON/OFF Button:
Push this button to start operation, push the button again to stop operation.
NOTE: The unit will initiate automatically the Energy Saver function under Cool, Dry, Auto (Only Auto-Cooling and
Auto Fan) modes.
CONNET button:
When connecting to Wifi for the first time, press the button for 3 seconds to initiate the Wifi connection mode. The LED
display shows AP to indicate you can set Wifi connection. If the connection is successful, the unit will enter Wifi
connection mode automatically and the CONNECT indicator illuminates. If connection is failed, the unit will exit the Wifi
connection mode. You can press and hold CONNECT and DOWN buttons at the same time for 3 seconds to turn off
WIFI function, and the LED display will show
“OF” for 3 seconds. Press CONNECT and UP buttons at the same time
to turn on WIFI function and the LED display shows
“ON” for 3 seconds.
TIMER
Button:
Set the timer ON (start to operate), and the timer OFF (turn off the operation). The timer ON and timer OFF light will
illuminate when the Timer ON or Timer OFF function is set.
Press or hold the UP and DOWN button to change the timer by 0.5-hour increment, up to 10 hours and then at 1 hour
increments up to 24 hours. The control to count down the time remaining until start.
The selected time will register in 5 seconds, and the system will automatically revert back to display the previous
temperature setting or room temperature when the unit is on. When the unit off, there is no display.
Turning the unit OF or OFF at any time or adjusting the timer setting to 0.0 will cancel the Timer ON/Timer OFF.
ECO Button:
This function is only available on COOL, DRY, AUTO (only AUTO-COOL and AUTO-FAN) modes. Push the button,
the fan will continue to run for another 3 minutes after the compressor stops. The fan then cycles on for 2 minutes at
10-minute intervals. If the room temperature goes above the set point, the compressor turns on and begins to cool.
MODE Button:
Press this button to select the desired operation mode from AUTO, COOL, DRY, and FAN as the following sequence.
AUTO ->COOL -> DRY -> FAN. The indicator light beside the button will be illuminated once the model is selected.
The unit will automatically initiate the Energy Saver function under Cool, Dry, and Auto (Auto-Cool and Auto-Fan only)
modes.