ATTACHING THE HUTCH
TO A DESK UNIT
The Hutch must be carefully
centered on the desk unit
as shown.
CONNECTOR BRACKET METHOD
A.
Carefully position the hutch onto the desktop as
described in hutch location instructions (above).
B.
With the hutch and desk aligned, position two
Connector Brackets (H9) on each Side Panel (A & B) in
the indicated locations. Mark the locations of the pilot
holes with a pencil.
C.
Using an electric drill and a 1/8" bit, drill the pilot
holes 1/2" deep.
NOTE:
Be careful not to drill all the way through the
side panels.
D.
Secure the hutch sides to the
desktop using the 5/8" Panhead
Screws (H7) through the four
Connector Brackets.
TAPE METHOD
A
. Carefully position the hutch onto the desktop as
described in hutch location instructions (above).
B.
Use a pencil to mark the location of the front, back
and outside edges of the hutch sides onto the desktop.
C.
With the assistance of another person, lift the hutch
off the desk. Lay the hutch down on its back. Remove
backing from one side of each Tape Strip (H10) and
place on the bottom edges of the Left Side (A) and the
Right Side (B).
D.
Remove the backing from other side of each Tape
Strip. With the assistance of another person, very
carefully align the hutch onto the pencil markings of
the desktop. When aligned, place the hutch on the
desk unit.
IMPORTANT!
It will be difficult to
remove or reposition the units
once joined.
H10
H10
H9
H7
H7
