Place the Left Side (A) and Right Side (B) on a clean carpeted surface with the pre-drilled holes
facing up. Insert the Leveler Inserts (H1) into the holes in the bottom edges of each Side. Using a
plastic mallet, tap until flush with the surface. Screw the Levelers (H2) into the Leveler Inserts.
Adjust Levelers when the assembled unit is in place.
#1
ASSEMBLE
DISASSEMBLE
Using the Rafix System:
Insert the Rafix Cams into the
appropriate holes. The flat edge of
the cam should be facing the edge
of the panel.
Slide Rafix Cams of the panel to be
attached onto the corresponding posts.
Using a #3 Phillips screwdriver, turn the
rotating portion of the Rafix Cam a 1/2
turn clockwise to secure.
IMPORTANT!
Do not exceed 1/2 turn when tightening
cams.
Turn 1/2 turn counterclockwise
to disassemble and remove panel.
When screwing post
into hole,
Do Not
over tighten. Screw
post down until
bottom face of post
flange just touches
board surface.
Flat
edges
must be
aligned
