Ironton 39109, Руководство пользователя, Страница: 6 / 12

Page of 12 6
9. Always keep guards in place.
10. Always start the cut gently. Do not bump or bang a wheel to start a cut.
11. Never make any freehand cuts. Always place the workpiece between the vise and fence when
making cuts.
REPLACING BLADE
CAUTION . Always ensure that the saw is switch off and unplugged from the power supply
before installing or removing a disc.
1. Loosen and remove the screws for shield flake with the wrench supplied (fig. 1).
2. Push in spindle lock lever (fig. 2), and at the same time use the wrench to
rotate the wheel until
the spindle lock lever engages locking the wheel in place (fig. 3).
Note: Once locked, the wheel will not rotate.
3. Hold the spindle lock lever in place and use the wrench to rotate the Hexagonal bolt in
counterclockwise direction. Then, remove the Hexagonal bolt, cable clam (63), upper flange away.
(fig. 3)
4. Raise the adjustable protecting cover at its highest position, then push in the spindle lock lever
until the spindle lock lever engages locking the adjustable protecting cover
hole . (fig. 4).
5. Replace the wheel, and turn it by hand, ensuring that it rotates fully and does not wobble unduly.
(fig. 5).
Note: Before install the wheel, check the wheel flanges to be sure they are in good condition. 6.
Release the adjustable protecting cover, then place the upper flange, cable clam, hexagonal bolt
through the threaded arbor hole and finger tighten.
7. Push in the spindle lock lever while tightening the Hexagonal bolt in a clockwise direction.
Note: Do not over-tighten the bolt, this may damage the blade, the flanges, and cable clam.