16
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
3. Also included with the unit are two 15” x 10” x 1” thick baffle
blankets. Install each blanket above the baffle board to each side
of the secondary support with the 15” side of the blanket from
front to rear of the unit. Make sure that the baffle blankets are
to the full rear of the unit.
CAUTION: Make sure the baffle blankets are down flat
on the baffle boards, pulled together in the center so
that no gaps exists between them and do not protrude
beyond baffle boards. It is critical that baffle boards
and baffle blankets are fully against the rear of the unit.
These brick sizes may be slightly smaller to adjust for steel and
firebrick tolerances beyond our control. Be sure to measure and
mark bricks with their numbers when removing.
WARNING: IF THE BRICKS ARE NOT INSTALLED EXACTLY AS
SHOWN BELOW, THEY COULD FALL OUT OF PLACE DURING
REFUELING OR BURNING OF THE STOVE CAUSING SERIOUS
INJURY.
Firebox Brick Layout as Viewed from the Front
Figure 14
* Bricks 6 and 10 fit up against the back of the firebox.
Figure 15 - Side Cut-A-Way View of Firebox
1” Thickness
Two Baffle Blankets Per Unit
1/2” Thickness
Four Boards Per Unit
15”
10”
4-3/4”
15”
Figure 16
Baffle Insulation Parts
24
E
25
H
26
E
5
F
4
F
2
F
1
F
3
G
14
F
15
F
17
F
18
F
16
G
23
B
22
B
20
B
19
B
10*
F
11
F
12
F 13
S
6*
F
7
F
8
F
9
S
21
K
Brick Sizes
B = 4-1/2”x 5-1/2”
E = 3”x 9”
F = 4-1/2”x 9”
G = 1-1/2”x 9”
H = 1-1/2”x 3”
K = 1-1/2”x 5-1/2”
S = 2-1/8”x 9”
Firebox
Brick
Baffle
Board
Baffle Blankets
