30
Manufactured By / Fabriqué Par:
INNOVATIVE HEARTH PRODUCTS
1502 14th Street NW
Auburn, WA 98001 USA
"PREVENT HOUSE FIRES"
Install and use only in accordance with manufacturer's installa-
tion and operating instructions and your local building codes.
CAUTION: Special methods are required when passing chimney
through a wall or ceiling, refer to local building codes. Do not
WARNING: (MOBILE HOME USA Only) An outside air inlet must
be provided for combustion, and be unrestricted while unit is in
use. Do not install appliance in a sleeping room. The structural
maintained. Approval void when label is missing.
Part No. 900448-00 Rev. 0, 05/2015
CHIMNEY & CONNECTOR: Minimum 6" diameter, minimum 24 MSG black steel connector pipe with UL103HT listed factory-built chimney
suitable for use with solid fuels or masonry chimney. Horizontal connection not tested, refer to local building codes for installation.
Clearances to connector shall be measured from 6" flue collar. Restrictions apply! Read instructions before installing.
Mobile Home approved Class A - UL 103HT chimney and double wall connectors:
• Security
• Projet
• Jakes Evans/GSW
• Dura-Vent
• Metal Fab
• Ameri-Tec
• Metalbestos
• Industrial Chimney
RESIDENTIAL chimney systems must be from the same brands as listed for mobile homes but connector pipe may be double wall,
single wall, or single wall with shield as listed above.
Connector pipe and chimney must be of the same brand.
COMPONENTS REQUIRED FOR INSTALLATIONS: Legs AND Bottom Heat Shield or Pedestal Base.
If optional blower is NOT used, Rear Heat Shield Block Off Plate shall be installed.
Model / Modèle: Performer™ ST210A / ST-210
Tested to/Testé selon: UL 1482, ULC S627
Type Of Fuel: Solid Wood Only
Optional Blower, Part No. H7917
Blower Electrical Rating: 120V, 60 Hz, 1 Amp
Do not route power cord under or in front of appliance.
WARNING: Do not obstruct the space beneath
the heater.
OPERATE ONLY WITH DOOR CLOSED.
† USA=8" (200mm) from door opening, Canada=8" (200mm) from sides and back of unit
* Mobile Home - USA only
ALCOVE DIMENSIONS (double wall pipe only): Minimum 48" (1219mm) Width, Maximum 48" (1219mm) Depth.
FLOOR PROTECTOR: The hearth and/or floor protection must be a non-combustible hearth/floor protector with a minimum thick-
ness of 3/8" (9.5mm), extending beneath the heater and to the front, sides, and rear as indicated.
NOTICE: All mobile home installations require outside air kits (OAK).
Clearance dimensions are to flue collar. If a single wall connector pipe with shield is used, a 1 inch air space is needed between pipe
and shield. Shield attaches to rear of stove pipe and must run from stove top to ceiling. Pipe shield shall be UL listed.
PIPE
INSTALLATION
A
C
E†
G
M
Single Wall
Residential
USA-16” CAN-483mm USA-24” CAN-635mm 8"/200mm USA-18” CAN-533mm 84”/2134mm
Single w/Pipe Shield Residential
USA-10” CAN-330mm USA-24” CAN-635mm 8"/200mm USA-18” CAN-533mm 84”/2134mm
Double Wall
Residential or Mobile Home*
USA-10” CAN-330mm USA-18” CAN-483mm 8"/200mm USA-15” CAN-450mm 72”/1829mm
Double Wall
Alcove
USA-10” CAN-330mm USA-21” CAN-559mm 8"/200mm N/A
72”/1829mm
HOT WHILE IN OPERATION. DO NOT TOUCH. KEEP CHILDREN, CLOTHING,
FURNISHINGS AND COMBUSTIBLE MATERIAL A CONSIDERABLE DISTANCE
AWAY. CONTACT MAY CAUSE SKIN BURNS. SEE NAMEPLATE AND INSTRUCTIONS. DO NOT OVERFIRE.
IF HEATER OR CHIMNEY CONNECTOR GLOWS, YOU ARE OVERFIRING. INSPECT AND CLEAN CHIMNEY
AND CONNECTOR FREQUENTLY. UNDER CERTAIN CONDITIONS OF USE, CREOSOTE BUILDUP MAY
.
H
T
R
A
E
H
N
O
Y
L
T
C
E
R
I
D
E
R
IF
D
O
O
W
D
LI
U
B
-
E
R
IF
E
T
A
V
E
L
E
R
O
E
T
A
R
G
E
S
U
T
O
N
O
D
.Y
L
D
IP
A
R
R
U
C
C
O
FEED DOOR MUST BE CLOSED DURING FIRING EXCEPT WHEN ADDING FUEL. KEEP ASH DOOR CLOSED
TO AVOID EXCESS HEAT. DANGER: RISK OF ELECTRICAL SHOCK. DISCONNECT POWER BEFORE SERVICING UNIT.
TYPE OF FUEL: SOLID WOOD ONLY.
CAUTION:
Report Number
14-185
Model
Performer™ ST210
Serial No./Numéro de sérle:
S210-
CONTACT YOUR LOCAL BUILDING OR FIRE OFFICIALS ABOUT
RESTRICTIONS AND INSTALLATION INSPECTION IN YOUR AREA.
LISTED ROOM HEATERS, SOLID FUEL TYPE ALSO FOR USE IN
MOBILE HOME INSTALLATION (USA ONLY) PURSUANT TO (UM)84-HUD
U.S. ENVIRONMENTAL PROTECTION AGENCY
DO NOT REMOVE THIS LABEL Made in U.S.A.
Date of Manufacture / Date De Fabrication
2017 2018 2019 JAN FEB MAR APR MAY JUN JUL AUG SEP OCT NOV DEC
JANV FEVR MARS AVR MAI JUIN JUIL AOÛT SEPT OCT NOV DEC
Minimum Clearance to Combustible Materials - Inches (millimeters)
SUITABLE FOR MOBILE HOME INSTALLATION
C
US
This wood heater needs periodic inspection and repair for proper operation. Consult the owner's manual for further information. It is
against federal regulations to operate this wood heater in a manner inconsistent with the operating instructions in the owner's manual.
Certification test emission value 4.2 g/hr per 2015 standard
SAFETY / LISTING LABEL -
MODEL S210A
2018
2019 2020
