Ironmaster Cable Tower, Инструкции по сборке и использованию

Страница: 2 / 7

2
Congratulations on your purchase of this fine Ironmaster product. The following instructions will help you assemble
the unit and provide some details on use as well. The only tools required are two
adjustable wrenches. Unpack all the parts and make sure you have received all the parts as shown on the exploded
view drawing and parts list. If you are missing anything or need anything, please call
Ironmaster right away and we will assist you. 800-533-3339.
Step 1: Assemble FRONT BRACKET #11 and
REAR LOW PULLEY BRACKET #15 to BASE
FRAME #9 using bolts #1, washers #3 and Nuts
#2.
Be sure to insert bolts from underside of
BASE FRAME with nuts and washers on top.
Refer to exploded view on page 7 for orientation.
Install forward pulley #15a using Allen head bolt
#15b and Nut #15c. No washer is used. Leave
nut hand tight for now.
Step 2: Assemble FRONT TUBE UPRIGHT #21
and SLIDE RAIL #17 using bolts #4 and washers #3.
Step 3: Assemble BENCH CONNECTOR #10
(chrome plated) to FRONT TUBE UPRIGHT #21
using bolt #4 and washer #3 on top and Bolt #1
and washer #3 on bottom. Be sure to locate hole
for bench pull pin on left hand side as shown.
Note: The connector can be adjusted up or down
to match up to the bench if
necessary.
Leave the bolts finger tight until
adjusted as a final step .
1
2
Step 4: Install ROUND TUBE #18 using bolt #5 and
washer #3. Push FOAM PAD SPACERS #14 on first then
the FOAM ROLLER PADS #13. Secure with bolt #7,
dome cap #12 and washer #8 as shown in exploded view.
Note: There are 3 height positions available so you can
select the most comfortable height for the leg hold down.
3
4
Front Bracket
Rear low Pulley Bracket
Slide Rail
Front
tube
upright
Forward
Pulley
Front tube upright
Bench connector
Bench pull pin locator
Round tube
Foam pad spacer
Foam roller pad