8 For more information, visit global.irobot.com
EN
Inspect the visual docking target, IR
window, and charging contacts to make
sure that they are clear of debris. Wipe
with a clean, dry cloth.
Removing Debris from Blower Cover
Inspect blower cover for any lint or debris
build-up, and wipe with a clean dry cloth
to remove.
Note:
To achieve optimal performance with
your robot and automatic dirt disposal, clean
and/or replace your robot’s filter as needed.
Install a new bag, sliding the plastic card
into the guide rails.
Discard the used bag.
Press down on the lid making sure that it
is completely closed.
4
3
5
Note:
This will seal
the bag so dust
and debris cannot
escape.
Replacing the Bag
Pull up on the plastic card to remove the
bag from the canister.
Lift up on the canister lid to open.
1
2
Cleaning the Visual Docking Target
Sensors, IR Window, and Charging
Contacts
Wipe sensors and charging contacts
with a clean dry cloth. You can
alternately use a pad of melamine foam
to remove built up debris on the robot
and CleanBase charging contacts.
Important:
Do not spray
cleaning
solution or
water onto
the sensors
or sensor
openings.
2
1
