iRobot DIRT DOG, Руководство пользователя

Страница: 14 / 18

14 iRobot Dirt Dog Owner’s Manual
1
Remove and empty
iRobot Dirt Dog’s bin
2
Clean iRobot Dirt Dog’s cliff detect
sensors (use compressed air)
3
Clean iRobot Dirt Dog’s brushes
A. Remove brush guard by pulling
both yellow tabs
Maintenance
To keep iRobot Dirt Dog running at peak performance, it is recommended that
you perform the following maintenance tasks every three uses:
Press button and
pull to remove bin
B. Remove and clean iRobot Dirt Dog’s
brushes. Remove brush caps and use
scissors to cut any hair wrapped around
the brush. Use the iRobot Dirt Dog
cleaning tool to comb hair from brush.
C. Remove and clean hair and dirt from
iRobot Dirt Dog’s yellow brush bearings.
TIP: Bin emptying and brush cleaning should be done after every 3- 5 cleaning
cycles depending on the amount of hair, dirt, and debris in your environment.
TIP: If you notice i Robot Dirt Dog picking up less debris from your floor, empty
the bin and clean the brushes.
Do not attempt to run i Robot Dirt Dog without the bearings. If you misplace
iRobot Dirt Dog’s brush bearings, visit www.roomba.com.au to buy
replacement bearings.
Excessive build up of hair in i Robot Dirt Dog’s brushes and bearings can
permanently damage iRobot Dirt Dog. Inspect brush bearings regularly.
Brush
bearings
(yellow)
Brushes
Brush
caps
(black)
Visit www.irobot.com/usetips
for instructional photos
Sensors Sensors