Black
IC-SLDCP6
EN
9
■
How to use the wall hanger
A magnet is built into the back of the body of this
product which can be positioned vertically and kept
on the wall by using the wall hanging component.
Please confirm the installation location
first
• The installation height is shown in the figure.
• Please install it near the socket.
960
～
970mm
Position
of screw
hole.
Socket
Install the wall hangers on the wall
When using adhesive sheets
The following materials and places are not applicable
Materials Polypropylene, polyethylene, soft rubber
Places
Paper wall, sand wall, fiber wall, easy
peeling paint wall, walls treated using
fluorine and silicone
Conspicuously uneven wall surfaces,
surfaces with high temperatures, highly wet
conditions, wall surfaces that are easily
permeated by water, outdoor walls, at and
around the joints on wall paper decorations
●
It is difficult to paste at low temperatures.
Please operate at room temperature
above 10
℃
.
●
Depending on the surface conditions and
conditions of the wallpaper and printed
plywood, the adhesive may be damaged
or discolored.
●
Different wallpapers may fall off easily,
please use screws for fixing.
●
When moving the site, the adhesive sheet
cannot be reused. Please use the reserve
adhesive film or the adhesive film sold on
the market (NITOMS strippable double-
sided adhesive film T3973).
①
The wall should be wiped clean before applying the
adhesive sheets.
②
Tear off the peeling paper on the adhesive sheet,
stick it on the wall, and press fully. It takes about
24 hours for the adhesive sheet to become fully
attached. Do not use it until then.
The wall hanger
Peeling paper
Using screws
• When the adhesive film cannot be used, do not
tear off the peeling paper. Instead, secure it using
screws.
• Insert the screw in the screw hole as shown in the
picture.
Screw
The wall hanger
Fix the charging power cord to the groove
through the wall hangers
Charging plug
Charging power cord
Groove
Attention
●
Do not force the
charging power
cord through the
wall hanging parts
to avoid damaging
the power cord and
causing fire.
Continued
→
