Black
IC-SLDCP6
EN
10
Preparation
Continued
Position the body of the vacuum vertically
and secure it on the wall hanger
• Place the body as close to the wall as possible.
• Make sure the magnet is fully attached to avoid
tipping.
Stand it as vertically
as possible against
the wall.
Attention
●
Do not stand the
vacuum outside of
the wall hanger, to
prevent it from sliding
down.
●
Be sure to stand the
vacuum upright. It if
is tilted, it could fall
over.
■
Tearing off the adhesive
sheet
When moving or discarding, tear off the adhesive
sheet as follows.
Insert a chord between the wall hanger
and the wall, slicing down and pulling out
while moving the sheet
Press gently with a paper towel (Or
towel) containing water, then press the
remaining adhesive for about 10 seconds
Residual adhesive
Please wipe gently with a dry paper towel
※
If it cannot be erased, repeat 2 or 3 times.
