When assembling or storing, lay the vacuum sideways to avoid it falling over . When completely assembled, vacuum can be
stored upright using the wall mount .
ASSEMBLY
Main body
Extension pipe
Collection head
Collection head
Main body
Brush
COMPLETE ASSEMBLY
HAND-HELD:
COLLECTION HEAD
HAND-HELD:
BRUSH ONLY
TO DISASSEMBLE
Line up the triangles (Δ)
on the collection head and
extension pipe and press
together firmly .
Line up the triangles (Δ)
on the extension pipe
and main body and press
together firmly .
Collection head can be
attached directly to the
main body without using
the extension pipe .
Main body can be used on
its own by pulling down the
brush head .
Please pay attention to
surroundings and use
caution when removing
the collection head and
extension pipe in order to
avoid hitting anything .
The cord hook on the back of the main body has a built-in magnet, allowing you to store the unit by placing it against the iron
plate of the wall mount . Unit can also be stored by leaning it against the wall .
MATERIALS
Polypropylene, polyethylene, soft rubber .
LOCATIONS
On wallpaper, textured wall, dry wall, easily
peeled paint, walls treated with fluorine or
silicone, etc .
Uneven surfaces
Areas of high heat and humidity
Areas that moisture can easily permeate
Outdoors
Wall seams and the surrounding areas
WALL MOUNT INSTALLATION
Using the Adhesive Sheet
1 If using the adhesive sheet, wipe off dust, oil, and moisture from the
surface the adhesive sheet will be placed on . Please do not use
chemical cleaning products to wipe the wall .
2 Peel the paper off the back of the wall mount and press it firmly into
place . See Mounting Height directions for ideal placement .
*It will take approximately 24 hours for the glue on the adhesive sheet
to set . Do not mount the vacuum until the adhesive glue is fully set .
Does not stick well in low temperatures . Installation should be done in areas with a temperature of
50°F/10°C or higher .
May damage or change color of certain surfaces, such as paint or varnished plywood .
Adhesive may not stick well to certain surfaces, such as wallpaper . In this case, use screws to
attach wall mount to the wall .
Original adhesive sheet cannot be reused if moving the wall mount . Please use a spare adhesive
sheet or double sided tape found in retail stores to reattach .
CAUTION
How to Remove Adhesive Sheet
1 If screws were used to install the wall mount, remove them .
2 Slide a thread in the gap between the mount and the wall . Move
the thread left and right, then pull off the wall mount . There will still be
adhesive residue .
3 Place a damp cloth or paper towel over the residue . Please hold in
place for about 10 seconds .
4 Please remove the damp cloth and lightly wipe away the remaining
residue with a dry cloth .
Wall mount parts
Adhesive sheet
on the back
Mounting Height
Screw
hole
height
38-38.5in / 96-97.5cm
5
6
