QPSK/IP DEMODULATOR
B11
Tuner Loop Out interface
B12
Tuner In interface
B13
Power socket, AC 90~260V
B14
CVBS1 Output interface
B15, B16
L-Audio-R interface
B20
Ethernet interface for remote management system
B21
Grounding
Power Supply
The power cord is inserted to an IEC main socket at the side of the device.
Check that the power cord is suitable for the country where the device will be used.
A standard power cord with a European DIN 49441 two pin main plug is delivered together with
the device.
The line fuses are housed in a small container at the side of the power supply connector.
Output Connectors
The ASI interface B9), B19) and ASI2 interface B8), B18) are two pairs of independent ASI
output. Both use female BNC connectors, with 75 Ohm impedance. The ASI interface B18) and
B19) are used as a redundant output of B8) and B9) out.
Note: the B8), B18) interface could be configured as SDI with Audio embedded. Please refer to
Chapter 7.3.5.
ASI Input Connector
The ASI input B17) is a 75 ohm female BNC connector.
RS-232 Interface
This interface is a 9-pins female sub-D connector. The RS-232 interface is only used for factory
software upgrade and configuration, so you are not allowed to connect any cable to the RS-232
connector, as that could damage the device.
Ethernet Interface
An RJ-45 connector B20) provides a remote control interface.
TS/IP Interface (Factory Optional)
An RJ-45 connector B1) provides a transport stream over IP input or output.
Function Block Diagram
The chart below shows the complete function block of This equipment. Where the arrow
‘’ or
‘dotted arrow’ indicates the transport stream flow. The function blocks embayed in the dotted line
are user-configurable.
8
