Specifications are subject to change without notice. - 16 - BLANKOM MPE 4400 EN 2020 V1.1
MPE-4400
Important Notes!
This manual is for use by qualified personnel only. Handling this device or system requires special electronic
technical knowledge. To reduce the risk of electrical shock or damage to the equipment, do not perform any
servicing other than the installation and operating instructions contained in this manual unless you are
qualified to do so. This device operates in the given voltage and frequency range without requiring manual
adjustment.
Do not open the top case w/o unplugged power source because serious injury or death may be the result!
Inside are components under risk from electrostatic discharge. To avoid equipment damages do not touch
these components or, observe the respective handling rules!
For continued protection against fire, the fuses may only be replaced by identical fuses with the same
electrical specifications which are designed for the corresponding fuse positions.
No part of this publication may be reproduced in any form or by any means or used to make any derivative
work (such as translation, transformation or adaptation) without the written permission from Blankom /
IRENIS GmbH.
IRENIS GmbH reserves the right to revise this publication and make changes in its content from time to time,
whereby it shall not be obligatory for IRENIS GmbH to provide notification of such revision or change.
IRENIS GmbH provides this manual without warranty of any kind, neither implied nor expressed, this includes
also any warranties regarding the merchantability and fitness for a particular purpose. IRENIS GmbH may
improve this manual or make changes in the products described herein at any point of time.
Installation Notes
All types of the IRENIS-BLANKOM family are 19“devices with 1 RU height designed for installation in 19” racks.
In addition to the front panel screws an internal module support is required at the rack.
Depending on the Frontend used and the operating adjustments, the SAT-RF-input ports carrying DC Voltage
(13V /18V, max. 400 mA).
By connecting a mains cable, the device can become functional without any auxiliary appliances. The power
supply units are designed for the wide range of 100-230V AC; a manual adjustment of the voltage is not
necessary.
For some models the second power connector is feeding another independent power supply for internal
redundancy. For a maximum of redundancy both power supplies should use different circuits.
All the outputs are decoupled from one another. Thus, the circuit does not have any effect on the functioning
of the device. Connections that are not required need not to be terminated.
Suggestion: CAT 6E Ethernet cable for GbEthernet, DSTP (double shielded twisted pair) for the streaming ports
